Configure Zenskar's Snowflake connector

​

🐕🦺 Setup guide

This guide will help you configure Zenskar’s Snowflake connector. Consequently, you can use Snowflake as a data source in Zenskar.

​

⚙️ Set up data source and type

1. Log into your Zenskar account.
2. In the left navigation bar, click Metering > Data Sources. In the top-right corner, click + ADD DATA SOURCE.
3. In the Set Up Source section of the Add New Data Source page, enter a name for the Snowflake data source connection.
4. Select Snowflake from the Source Type dropdown.

​

⚙️ Configure data source

In the Source Config section of the Add New Data Source page, add the following details:

​

Select tables and columns to sync

​

Select tables to sync

If the connector is configured correctly, you will be asked to select the tables to sync.

​

Select columns to sync

A table can be expanded to select the columns to sync.

• A cursor can be set against a column.
• A column can be set as the primary key.

​

Select sync frequency

A sync frequency can also be configured. Finally, click on the FINISH SETUP button to save the connector.

---